Friday, May 01, 2009

George Koch And Excel Combine To Transport Cars

Excel Automation has designed and installed a 70-metre vehicle-handling system to transport the Ford Transit through an underbody treatment plant made by George Koch for Ford's Southampton factory. The system can handle thirty vehicles an hour. The circular system comprises a 6in overhead 'Power and Free' conveyor with three pneumatic pusher-assemblies and two scissors-lifts that raise and lower vehicles at the load and unload positions.

The overhead conveying system is equipped with seven gull-wing type vehicle-carriers that transport the Transit vans. The automatic finishing booth designed by George Koch uses two spray robots to apply an anti-corrosion material to the underside of Transit vans in the final operation before vehicles leave the plant. A manual back-up booth provides security of production. At ground level, Transit vans are driven to a vehicle-load area and onto a platform mounted on one of the scissors-lifts, which is installed in a pit.

A series of wheel guides are positioned to ensure the vehicle is central to the load station. Once the vehicle is in the correct position, the driver/operator applies the handbrake, switches off the engine and exits the vehicle, pressing a push-button to start the loading operation once he is clear of the area. The scissors-lift then raises the vehicle to the transfer height approximately 2.5-metres above ground level.

A pneumatic pusher then moves a carrier with open gull-wing arms into position around the vehicle, which is then held behind a conveyor-stop. The arms of the carrier close so that the load-bearing fingers are beneath the vehicle and the scissors-lift platform. The scissors-lift then lowers and the carrier's fingers pass through slots in the platform and engage on the wheels of the van. Carriers accommodate short and medium wheel-base vehicles. The scissors-lift continues to lower until it is clear of the carrier, leaving the Transit captive in the gull-wing carrier.

Once the scissors-lift is clear, the conveyor-stop opens and the carrier is pushed forward, where it engages with a pusher-dog mounted on the process chain of the Power and Free conveyor. The process chain then pushes the carrier through the automatic booth, where the underside of the vehicle is sprayed by two Fanuc robots that apply the coating to all accessible areas of the underside. The robots are programmed to avoid sensitive underbody components such as catalysts and exhaust systems, depending on which Transit model is in the booth.

The vehicle progresses through the booth at process speed to a second enclosure where the coating is applied manually to any areas that the robots were unable to spray. In the event of a robot failure, the manual enclosure can be used as a back-up facility. At the end of the cycle, the process chain delivers the vehicle for unloading to a conveyor-stop positioned over the second scissors-lift. At this point the process-chain dog is detached from the carrier and the chain is routed away to the load position. The unload cycle is the reverse of the load cycle. The carrier, still holding the vehicle, is held in the conveyor-stop.

The scissors-lift raises and the fingers in the platform pass through slots on the carrier and engage on the wheels of the Transit. The scissors-lift continues to rise, lifting the vehicle clear of the carrier arms. The lift then stops, the carrier arms open and the lift lowers the vehicle to ground level, where an operator drives it away. The empty carrier is then transferred back to the load station by a series of pneumatic pushers and the sequence repeats to pick up the next vehicle.

No comments: